HS5331 DIY FM Radio Electronic Soldering Kit Dual Channel Receiver With Charging 87MHz-108MHz RDA5807 DC 3.0V for Students/Beginners

HS5331 DIY FM Radio Electronic Soldering Kit Dual Channel Receiver With Charging 87MHz-108MHz RDA5807 DC 3.0V for Students/Beginners

1.Introduction:

 

 

It is a 3.0V RDA5807 87MHz-108MHz FM Radio Receiver DIY Kit.It is a simple FM receiver and can be used all over the world with power by AA*2 battery. It is very suitable for users to learn electronic circuits, practice and proficient soldering skills, and enhance electronic professional knowledge and interest.

 

2.Feature:

1>.Universal frequency 87MHz-108MHz

2>.Perfect simple circuit

3>.DIY hand soldering

4>.Stable fixing bracket

5>.Support battery charging function

 

3.Parameter:

1>.Product Name:RDA5807 FM Radio Receiver DIY Kit

2>.Work Voltage:DC 3.0V

3>.Power Type:AA*2 Battery(Not Included!)

4>.Channel: Dual channel

5>.FM Frequency:87MHz-108MHz

6>.Frequency accuracy:0.1MHz

7>.Equivalent noise:>=30dB

8>.Work Temperature:-25℃~85℃

9>.Work Humidity:5%~95%RH

10>.Size(Installed):123*95*56mm

 

4.Function:

1>.Buttons VOL- and VOL+ are used to adjust volume.

2>.Buttons FM- and FM+ are used to switch FM stations.

3>.The toggle switch on the side is the power switch.

 

5.Application:

1>.Training solderingskills

2>.Student school

3>.DIY production

4>.Project Design

5>.Electronic competition

6>.Gift giving

7>.Crafts collection

8>.Home decoration

9>.Souvenir collection

10>.Graduation design

11>.Holiday gifts

 

6.Installation Tips:

1>.User needs to prepare the solderingtool at first:

1.1>.Small screwdriver

1.2>.Small wire cutters

1.3>.Fine tip soldering iron(Recommend using a fine point soldering tip)

1.4>.Good quality small gauge solder(recommend no larger than 1.0 mm)

1.5>.Magnifying glass

2>.Please be patient until the installation is complete.

3>.The package is DIY kit.It need finish install by user.

4>.The soldering iron can't touch the components for a long time(1.0 second), otherwise it will damage the components.

5>.It is recommend building the project starting with the lowest components first and working up to the highest components. This is a common practice as it makes it easier to hold the low components on the board while soldering

6>.Pay attention to the positive and negative of the components.

7>.Strictly prohibit short circuit.

8>.User must install the LED according to the specified rules.Otherwise some LED will not light.

9>.Install complex components preferentially.

10>.Make sure all components are in right direction and right place.

11>.Check that all of the LED can be illuminated.

12>.It is strongly recommended to read the installation manual before installation!!!

13>.Please wear anti-static gloves or anti-static wristbands when installing electronic components.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: