HR0588 3D Printer Heated Bed Power Module /Hotbed MOSFET Expansion Module 25A

Description:

1. This module can be used in both Chitu motherboard, and other open 3D Printer motherboards.
2. This high power module helps your 3D printer equipped with the Chitu controller board (capable of max 15A) become even more powerful. With this addon module to your Chitu board you can lead the maximum current up to 25A.
3. If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board.

Note:

This module under the premise of normal cooling, found at I (Max) = 25A stable work situation, the process of using the current not exceed 25A

 

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: