• The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode.
• Jog type : the initial state is low , high touch , do not touch is low ( similar touch of a button feature )
• Module can be installed in such as surface plastic, glass of non-metallic materials
• In addition to the thin paper ( non-metallic ) covering the surface of the module , as long as the correct location of the touch , you can make hidden in the walls, desktops and other parts of buttons
Features:
• Low power consumption
• Power supply for 2 ~ 5.5V DC
• Can replace the traditional touch of a button
• Four M2 screws positioning holes for easy installation
• Specification:
• Item
|
• Min
|
• Typical
|
• Max
|
• Unit
|
• Power supply voltage VCC
|
• 2.0
|
• 3
|
• 5.5
|
• V
|
• Output high VOH
|
• -
|
• 0.8VCC
|
• -
|
• V
|
• Output low VOL
|
• -
|
• -
|
• 0.3VCC
|
• V
|
• Output Pin Sink Current (@ VCC = 3V, VOL = 0.6V)
|
• -
|
• 8
|
• -
|
• mA
|
• Output pin pull-up current (@ VCC = 3V, VOH = 2.4V)
|
• -
|
• 4
|
• -
|
• mA
|
• Response time (low power mode)
|
• -
|
• -
|
• 220
|
• mS
|
• Response time (touch mode)
|
• -
|
• -
|
• 60
|
• mS
|
• Size
|
• 24x24x7.2
|
• mm
|
• Touch Sensor Interface :(the last picture show)
-Control Interface : A total of three pins (GND, VCC, SIG), GND to ground , VCC is the power supply , SIG digital signal output pin ;
-Power Indicator : Green LED, power on the right that is shiny ;
-Touch area : Similar to a fingerprint icon inside the area , you can touch the trigger finger .
-Positioning holes : 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install , to achieve inter- module combination ;