| Brand: | Haitronic |
| Product Code: | HS6660 |
| Availability: | 99999 |
HS6660 DC6.5V-50V 380W BLDC Three-Phase DC Brushless Motor Controller Hall Driver Motor Control Drive Module Pwm Signal Input
Product Features:
This driver is a DC three-phase brushless hallless control board
The motor can work normally without hall
BLDC wide voltage 6.5-50V high power 380W DC three-phase high-speed brushless non-inductive controller
New PWM signal input, support 3.3V system
PLC 0-5V tactile, signal input control
External signal input special instructions:
1.V/P short connection is the PWM signal input is effective in identifying the real PMW signal to support 3.3V system, you need to input the PMW signal from the two ports of the terminal (PWM GND).
2.V/P short contact is disconnected is 0-5V mimic signal input effective (factory default disconnected), in the analog input, you can use the board comes with a potentiometer voltage divider speed control, if you want to external 0-5V mimic signal input must be unplugged from the board jumper cap to cut off the potentiometer divider signal, and then from the terminal two ports (0-5 GND) to enter the 0-5V mimic signal, the voltage is maximum Do not exceed 5V
3. Forward and reverse and brake through a switch ground is low-level effective, can also be external MCU to the low-level signal, the front row of terminals, are weak electrical signals directly into the MCU master control, can not touch and contact with high voltage and strong current.
Interface description:
1. U V W 3-phase line output connected to the brushless motor
2. 5V GND Main board comes with 5V (current does not exceed 200MA)
3. VCC GND mains power supply (external DC power supply)
4. SC speed pulse signal output (only interface, no technical support)
5. DIR Forward and Reverse Control (can be switched to ground)
6.BRAKE Brake Control (can be switched to ground)
6.0-5V PWM speed control signal dual inputs (the board comes with potentiometer speed control can also be switched through the jumper external 0-5V touch the proposed amount of PWM duty cycle signal input speed control)
All chip technology, stable performance, humanized design, interface with all terminals standard heat sink on-board speed potentiometer to the hands of the power can be used to save time and worry!
Main board specifications parameters:
Product name: zs-x11f-2
Working voltage: 6.5-50V
Driving current: rated 16A plus air-cooled cooling 30A
Maximum power: 380W
Over-current protection: Yes
Blocking protection: Yes (after blocking the current automatically drops to hit the isolation operation)
Over-temperature protection: Yes (over-temperature power halved)
Maximum speed: 224000 RPM (2-pole motor), 74000 RPM (6-pole motor), 40000 RPM (12-pole motor), 35000RPM (14-pole motor).
Product size: L63MM*W45MM*H31MM
Weight: 76g
Attention:
1. Power supply on the motherboard power supply positive and negative polarity reversal will cause permanent damage to some of the chips on the board (even if 1 second can not)
2. In normal operation, the motor output has a sampling overcurrent protection, due to the module power current are very large Please do not short-circuit the module is not working properly, but the short-circuit has the possibility of burning line burst tube, the first wiring test please use a small current and low voltage test, to be ok, and then through the high current and high voltage, due to the bare board module for sale, pay attention to the insulation of wiring wires and forbidden to touch the board parts of the strong voltage
3. Do not connect with the drive module voltage, current, power phase does not match or far from the motor.
Product list:
1X driver board
